2.5 liter l4 engine emission controls
| № | Name | Ext. inf. | A* | Part number | A |
|---|---|---|---|---|---|
| 001 | Nut (m6 x 1. 9) | - | |||
| 002 | Air cleaner | - | |||
| 003 | Motor, air cleaner diaphragm | - | |||
| 004 | Hose (3/4") | - | |||
| 005 | Pipe, c/case vent | - | |||
| 006 | Grommet, c/case vent conn | - | |||
| 007 | Tube, carb air preheat | - | |||
| 008 | Elbow, deceleration valve hose to a/cl | - | |||
| 009 | Screw (m6 x 1 x 20) | - | |||
| 010 | Clamp, adjust (1/2" to 1") | - | |||
| 011 | Pipe, pulsair | - | |||
| 012 | Washer, flat (m10) | - | |||
| 013 | Nut, hex (m10 x 1. 5) | - | |||
| 014 | Nut, hex (m6 x 1. 5) | - | |||
| 015 | Bracket, pulsair asm to cyl head | - | |||
| 016 | Screw (m6. 3 x 1. 8 x 12) | - | |||
| 017 | Bracket, enrichment & part throttle | - | |||
| 017 | Switch, enrichment vac (w/female conn-natural) | - | |||
| 017 | Switch, part throttle vac (w/male conn-black & white) | - | |||
| 018 | Pulsair | - | |||
| 019 | Solenoid, distr vac | - | |||
| 020 | Valve, deceleration | - | |||
| 021 | Adapter, carb to intake manif | - | |||
| 022 | Gasket, egr valve | - | |||
| 023 | Valve, egr | - | |||
| 024 | Gasket, adapter | - | |||
| 025 | Harness, closed loop | - | |||
| 026 | Calibrator, carb controller | - | |||
| 026 | Controller, carb | - | |||
| 027 | Bolt, w/clip, module brkt (9. 667) | - | |||
| 028 | Bracket, control module-lh | - | |||
| 029 | Nut "u" (m4. 2 x 1. 41) | - | |||
| 030 | Screw (m4. 2 x 1. 41 x 13) | - | |||
| 031 | Nut (m5 x 0. 8) | - | |||
| 032 | Wire, closed loop i/p jumper | - | |||
| 033 | Suppressor, noise modulator | - | |||
| 034 | Wire, warning lamp jumper | - | |||
| 035 | Screw (m4. 2 x 1. 41 x 20) | - | |||
| 036 | Bracket, control unit-upr ("x") | - | |||
| 037 | Sensor, oxygen | - | |||
| 038 | Bracket, control unit-lwr ("x") | - | |||
| 039 | Screw (m4. 2 x 1. 41 x 13) | - | |||
| 040 | Nut, nylon | - | |||
| 041 | Stud, shroud to manifold | - | |||
| 042 | Shroud, w/adapter, preheater | - | |||
| 043 | Screw (m4. 2 x 1. 41 x 20) | - | |||
| 044 | Duct, air intake-rear | - | |||
| 045 | Adapter, air intake duct-rear | - | |||
| 046 | Hose, air | - | |||
| 047 | Duct, air induction-front | - | |||
| 048 | Strap, wire harness | - | |||
| 049 | Clip, wire harness | - | |||
| 050 | Washer, ext lock (7/16") | - | |||
| 051 | Screw (m10 x 1. 5 x 16) | - | |||
| 052 | Bracket, induction duct mtg | - | |||
| 053 | Screw (1/4"-14 x 3/4") | - | |||
| 054 | Adapter, air induction-rear | - | |||
| 055 | Clamp, hose | - | |||
| 056 | Valve, fuel vapor press control | - | |||
| 057 | Canister, fuel vapor | - | |||
| 058 | Clip, canister | - | |||
| 059 | Harness, evap emission (incl #56) | - | |||
| 060 | Cap, port (5/32" fitting-rubber) | - | |||
| 060 | Connector, carb control hose | - | |||
| 060 | Harness, emission cont vacuum hose (complete) | - | |||
| 060 | Tee, conn (3/16" dia) | - | |||
| 060 | Tee, vac hose (3/16" x 3/16" x 3/16") | - | |||
| 060 | Tee, vac reg to source (3/16" x 3/16" x 1/4") | - | |||
| 060 | Valve, emiss vac hose (4 ports) | - | |||
| 060 | Valve, emission vacuum | - | |||
| 060 | Valve, vac hose harn (in-line) | - | |||
| 061 | Switch, thermal vac distributor | - | |||
| 062 | Valve, egr control | - | |||
| 063 | Grommet, crankcase vent | - | |||
| 064 | Valve, crankcase vent | - | |||
| 065 | Hose, c/case vent valve to carb | - | |||
| 066 | Grommet, c/case vent pipe (3/4" id x 1 1/4" od) | - | |||
| 067 | Connector, hose | - | |||
| 068 | Valve, carb vac break | - | |||
| 069 | Retainer, vac switch | - |
Copyright © 2024 WebAutoCats.com. All rights reserved. Terms of Use | Privacy Policy